Flashforge PETG 1kg 1.75mm - Fits the Creator Pro, Guider 2/2S & Creator 3 Colour:Green when all the doors are

when all the doors are closed

3mm quick change nozzle for the Flashforge Adventurer 3 & 4

but not as much

Peel Away - PolySupport™ is a dedicated support material engineered to break away easily by hand without the risk of damaging the part

Creates a safe and stable environment

Flashforge PETG 1kg 1.75mm - Fits the Creator Pro, Guider 2/2S & Creator 3 Colour:Green when all the doors areFlashforge PETG is great quality and a very reliable filament with extra toughness over PLA. It prints at the same temps as Flashforge ABS with a temperature window of 220 240 degrees C. The recommended bed temp is 80 degrees C. You may need to decrease your extrusion ratio a little if you experience any burnt lumps building up on your nozzle and dropping off on your prints PETG in general is sensitive to over extrusion. The 1kg spools fit the Creator