easy35 v1 Film Holder for Minox easy120 Minimal setup

Minimal setup

Such use cases might be to maximize your resolution by avoiding cropping in post processing

we have made an 8mm holder that will accommodate normal 8mm film and Super8 film

We made sure this helicoid not only fits perfectly onto the easy35 and easy120 tubes

Table must have a non-slanted edge and be less than 3

easy35 v1 Film Holder for Minox easy120 Minimal setupThe easy35 v1 Minox holder allows you to scan 9. 2mm Minox film that has a frame size of 811mm or less. The holders fits into the easy35 v1 system just like any other compatible holder by sliding out the existing holder and sliding in this new holder. The gate dimensions are allowing you to see the whole frame. Due to the small size of the frame, we cannot guarantee that the whole frame will be seen but have designed the holder to show the largest