1/2X4X96FSB Bucket Pin This bolt on Cutting Edge

This bolt on Cutting Edge has an industry standard part number of 8E4567 and has 3 bolt holes

This bolt on side cutter (can be welded on) is designed for mini-excavator buckets and has an industry standard part number 20s-70-71330 also known as MSC-R

2 pads are used on each stabilizer arm

A bucket pin shim will work just fine if it is a little larger than the Outer Diameter of your pin but not if it is smaller (it has to fit around the pin)

This tooth uses pin 2MG10/15PR our # MG10/15PR

1/2X4X96FSB Bucket Pin This bolt on Cutting Edge1 2" x 4" x 96" Flat single bevel, weld on cutting edge. Good to weld under the front edge of your bucket to give it a wear surface or to replace the front lip of your bucket. If it becomes the new front lip of your bucket you can drill or blow holes in it to match a bolt on edge if you like.